Drill Holes and Secure the Strike Plate Use a 7/8″ spade bit to drill two overlapping holes in the doorframe for the deadbolt. Mortise the area around the hole so the strike plate will fit flush with the doorframe. Drill pilot holes and secure the striker plate with screws.Click to see full answer. Consequently, how do you fix a strike plate? The strike plate can be moved or slightly modified to fix this condition. Place one layer of masking tape across the strike plate, then cut out the center. Remove the striker plate screws, then remove the strike plate. Bend the strike plate’s latch pocket tab straight with the pliers. One may also ask, how do you cut a hole in a strike plate? Position the strike plate on the jamb so it is centered on both lines. Score around the plate with a sharp utility knife. Using a sharp 1-inch-wide chisel, cut a series of parallel lines into the jamb about 1/4 inch apart, staying within the scored lines and holding the chisel perpendicular to the wood. Secondly, how do you replace a strike plate? Remove the old strike plate from the doorjamb by unscrewing it from the wall. Align your new strike plate over the screw holes already in the wood, making sure that the curve of the plate is facing in the direction from which it will be receiving the latch. Then, just screw the new strike plate into place.What does a strike plate do?A strike plate is a metal plate affixed to a doorjamb with a hole or holes for the bolt of the door. The strike plate protects the jamb against friction from the bolt and increases security in the case of a jamb made of a softer material (such as wood) than the strike plate.

ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZqSao5Virm6%2F06ugpJ1dpbmiwMRmn6iklWQ%3D